If you wish to drop your second anchor in any other place than directly to leeward of the first, you may, without using your long boat, warp the vessel over the berth intended for your second anchor. You should always moor so that you may ride with an open hawse in the direction from which you are liable to the strongest winds. If you have chain cables, you may moor with both cables bent to a swivel just clear of the hawse hole, one chain coming in-board. In moderate weather, and where you are not in a strong tide-way, it will generally be sufficient to let go one anchor, since, if you have out a good scope of chain, you will ride by the bight of it, and it will require a very heavy blow to bring a strain upon the anchor. In mooring, you should always have a shackle near the hawse-hole, for clearing hawse. If it is just abaft the windlass, it will be convenient in case you wish to slip your cable. A FLYING MOOR--sometimes called a RUNNING MOOR.--Have both anchors ready for letting go, with double the scope of chain you intend to ride by ranged for the weather anchor, and the riding scope of the lee chain. There are two ways of making a flying moor. One is to clew up everything and let go the first anchor while she has sufficient headway to run out the whole double range. When it is all out, or just before, luff sharp up, brace aback to stop her way, and let go the other anchor. Then heave in on the first and light out on the second, until there is the same scope to each. This mode is almost impracticable in a merchant vessel, where there is but one deck, and where the chain may have to be paid out over a windlass, since the headway would in most cases be soon stopped. The other mode is, to lay all flat aback, and the moment the headway ceases, let go your first anchor, paying out chain as she drops astern, until double your riding scope is out. Then let go your second anchor and heave in on the first. CLEARING HAWSE.--When a vessel is moored she may swing so as to get a _foul hawse_; that is, so as to bring one cable across the other. If one cable lies over the other, it is called _a cross_. When they make another cross, it is called an _elbow_. Three crosses make a _round turn_. The turns may be kept out of a cable by tending the vessel when she swings, and casting her stern one side or the other, by the helm, jib and spanker. To clear hawse, trice the slack cable up by a line or a whip purchase and hook, below the turns. Lash the two cables together just below the lowest turn. Pass a line round the cable from outside, following each turn, and in through the hawse-hole of the slack cable, and bend it to the shackle. Unshackle and bend a line to the end. Rouse the cable out through the hawse-hole, slacking up on the end line, and tricing up if necessary. Take out the turns by the first line passed in, and haul in again on the end line. Shackle the chain again, heave taut, and cast off the lashings.