In order that wheat may be made into bread it is necessary that it should be reduced to powder. In prehistoric times this was effected by grinding the grain between stones. Two stones were commonly used, the lower one being more or less hollowed on its upper surface so as to hold the grain while it was rubbed by the upper one. As man became more expert in providing for his wants, the lower stone was artificially hollowed, and the upper one shaped to fit it, until in process of time the two stones assumed the form of a primitive mortar and pestle. The next step in the evolution of the mill was to make a hole or groove in the side of the lower stone through which the powdered wheat could pass as it was ground. This device avoided the trouble of emptying the primitive mill, and materially saved the labour of the grinder. Such mills are still in use in the less civilised countries in the East, and are of course worked by hand as in primitive times. They gradually developed as civilization progressed into the stone mills which ground all the breadstuffs of the civilised world until about 40 years ago. The old fashioned stone mill was, and indeed still is, a weapon of the greatest precision. It consists of a pair of stones about four feet in diameter, the lower of which is fixed whilst the upper is made to revolve by mechanical power at a high speed. Each stone is made of a large number of pieces of a special kind of hard stone obtained from France. These pieces are cemented together, and the surfaces which come into contact are patiently chipped until they fit one another to a nicety all over. The surface of the lower stone is then grooved so as to lead the flour to escape from between the stones at definite places where it is received for further treatment. The grain to be ground is fed between the stones through a hole at the centre of the upper stone. It has been stated above that the surfaces of the two stones are in contact. As a matter of fact this is not strictly true. The upper stone is suspended so that the surfaces are separated by a small fraction of an inch, and it will be realised at once that this suspension is a matter of the greatest delicacy. To balance a stone weighing over half a ton so that, when revolving at a high rate of speed, it may be separated from its partner at no point over its entire surface of about 12 square feet by more than the thickness of the skin of a grain of wheat, and yet may nowhere come into actual contact, is an achievement of no mean order. Stone mills of this kind were usually driven by water power, or in flat neighbourhoods by wind power, though in some cases steam was used.