"I wrote with one when a boy (1822 to 1826), having found several in a stock of old steel waste in the warehouse of a relative, a retired ornamental steel worker, at Wolverhampton. These pens were made (so I was told) for the London market, late in the last or early in the present century. Certainly they were made fifteen or, perhaps, twenty years, when I found them, as the manufactory in which they had been produced had been closed the former number of years. They consisted of a holder of steel, with flutings and facets. One was solid and tapered to lighten it; the other had a barrel with an internal screw. The pen had two screws; one was used to screw the pen into the barrel for use, and the other to secure it when turned inwards as a protection when not in use, or to carry in the pocket." The following letter from Mr. Alderman Manton to Mr. Sam: Timmins makes us acquainted with another manufacturer of steel pens: "THE METAL PENS OF 1823.--In a badly-constructed and unsanitary manufactory (Mr. James Collins's), at the back of 119 Suffolk Street, (Birm.), I witnessed the process of making silver and _steel_ pens. As both metals were manufactured in the same manner, one description will serve. It will be remembered by a few that at that time there was a patent silver pencil case somewhat extensively manufactured, which in addition to the pencil, had a penknife, _pen_ and toothpick provided. The penknife was supplied by two brothers--_Joseph and William Gillott_--who at that time rented a small shop in a corner of the yard belonging to the rolling mill of George and P.F. Muntz, Water Street, and from whose engine they obtained the small amount of steam power needed. The process of making the pens was as follows: Two narrow strips were cut from a sheet of silver or steel; they were then, by the help of the hammer and a lead cake, or piece of hard wood, curved. Afterwards the two strips were placed opposite to each other on a well-polished steel wire, and drawn through a draw-plate, the wire and plate being supplied by Wm. Billings, a celebrated tool manufacturer, occupying premises near the top of Snow Hill (Birm.). By the aid of a press, a small hole was made at a distance of half an inch or five-eighths from the end, the slit was then made by a fine saw made of watch springs. A bent pair of shears was used for cutting the end of strip into the shape of a pen; and a half-round file or smooth was used for finishing the pen. The pen was then sawn off the strip by the same saw which was used for slitting the pen. The only hardening process was the friction of the draw-plate and steel wire. I not only witnessed the process, but was a manipulator. The cost of making at that time, by a journeyman, was 2d. each; by an apprentice, about one-third of that amount. Within less than thirty years of that time, in a manufactory adjoining my own, pens were made and sold (wholesale) at 2d. per gross, and a box containing them into the