A natural desire on the part of the governments of various nations was to secure increased speed. They sent out requirements to submarine boat builders calling for increased speeds within certain limits of cost. The submarine boat builders said: "Certainly we can give you increased speed if the engine builders can give us engines of the necessary power to go into the available space, and within a certain weight, to thus enable us to get the power plant within a certain size vessel possessing the fine lines necessary to give the required speed." The engine builders said _they could do it_. The first, as I remember, to break away from the slow-speed, heavy-duty type was a celebrated Italian firm. Then two large and well-known German firms followed; then a celebrated English firm, and certain American firms claimed that they could build reliable, compact, high-speed engines on very much less weight than we had been using. I remember one American firm which offered engines as low in weight as twenty pounds per horsepower. Fortunately, we had sense enough to refuse to accept an engine so light as that, but we, as well as all other submarine boat builders both in this country and abroad, did accept contracts which required engines very much less in weight than the old, slow, heavy-duty type first used, and there has been "wailing and gnashing of teeth" both by the submarine boat builders and by the engine-room forces in the world's submarine navies ever since. The first light-weight engines built by the Italian firm "smashed up" in short order. The German engines followed suit, and the losses to this firm, or to the shipbuilders, must have been enormous, as a large number of engines were built by them before a set was tested out in actual service. The test of an engine in the shop, on a heavy foundation, open to inspection on all sides, and with expert mechanics in constant touch with the engine, does not mean that this same engine will prove satisfactory in the restricted space available in a submarine boat when run by other than expert engine-building mechanics. I was present at a shop test of one of the German engines referred to, and under shop conditions it appeared to work very well--so well, in fact, that I took an option for my firm to build from the same designs in America. When the engine was tried out, however, in one of the German submarines it rapidly deteriorated and pounded itself into junk in a few weeks. Cylinders and cylinder heads cracked, bed-plates were broken, and crank-shafts twisted or broken. It was evident that the design was too light all the way through.