The surface of the deal or other wood on which the veneer is to be laid, is in like manner planed with these parallel indentations; and then the process of veneering proceeds. The wood, having been well warmed before a fire, is coated with warm melted glue; and the piece of veneer is laid down flat on the veneered surface, and rubbed backwards and forwards, in order that the glue which is between the veneer and the under-wood may be pressed into all the little grooves produced by the plane. When the glue begins to get cool, the veneer can no longer be pressed to and fro, and is then left. This glueing has the general effect of making the veneer adhere to the foundation beneath; but there are parts where, from the accumulation of too much glue in one part, or from the presence of air which had not been expelled by the pressure of the hands, the veneer rises up as a kind of blister, convex on the upper surface. The workman employs a veneering hammer to level these protuberances. This veneering hammer is a piece of wood three or four inches long, and an inch in thickness, having a straight strip of iron plate fixed to one edge. The workman, placing the iron edge down upon the veneer, presses on the block of wood with his hand, and works all over the surface of the veneer, expressing all the superfluous glue from the parts which had formed the protuberances. As this redundant glue must have some place from whence to escape, the workman begins rubbing at the centre, and thence proceeds towards the edge, at which the glue finally exudes. There is a curious plan adopted for ascertaining whether there are any parts, imperceptible to the eye, where the veneer does not adhere closely to the foundation--viz., by sound. The workman strikes the veneer all over with a wooden or other hammer; and if the sound be distinct and solid, he knows that the proper degree of adhesion has taken place; but if the sound be hollow and dull, it indicates the existence of a vacant space between the veneer and the foundation; and a greater degree of rubbing or pressing is consequently necessary. If the surface of the piece of veneer be of large dimensions, two workmen are required to level all parts of the veneer before the glue gets cold and loses its fluidity.