_Detection of chloroform._--An adulteration with chloroform, if moderate, cannot always be detected by the odor and taste. In most cases, chloroform will considerably increase the specific gravity of the oil. Bring into a test-tube 15 drops of the suspected oil, 45 to 90 drops of alcohol, and 30 to 40 drops of dilute sulphuric acid. After thorough shaking, add 2 or 3 shavings of zinc sheet and heat until a vigorous evolution of hydrogen takes place. After again shaking, set the whole aside, and heat again when the evolution of gas becomes weaker. This heating and gentle shaking of the fluid is several times repeated. After 20 to 25 minutes, compound the fluid with an equal volume of cold distilled water, shake vigorously and filter through a paper-filter moistened with water. Strongly acidulate the filtrate with nitric acid and compound with nitrate of silver solution. If chloroform is present, turbidity or a precipitate of chloride of silver appears. _Detection of benzine._--An adulteration with benzine can be readily detected only in oils specifically heavier than water. The separation of benzine is effected by distillation from a small glass flask in the water bath. The distillate together with an equal volume of nitric acid of 1.5 specific gravity is gently heated in a test-tube. A too vigorous reaction is modified by cooling in cold water, and a too sluggish action quickened by gentle heating (dipping in warm water). If the mixture has a yellow color, dilute it with water, shake with ether, mix the decanted ethereal solution with alcohol and hydrochloric acid, add some zinc and place the whole in a lukewarm place to convert the nitrobenzol formed into aniline. After evolution of hydrogen is done, neutralize with potash lye, shake, take off the layer of ether, let the latter evaporate and add to the residue a few drops of calcium chloride solution. If benzine is present, a blue-violet color reaction takes place.