pour off the acid, and examine whether it has sufficiently corroded any part of the work; if so, lay a mixture of warm tallow and linseed oil over such parts with a hair pencil, and again pour on the acid. In half an hour more the acid may be poured off, and the plate being warmed, the border may be removed, and the varnish may be wiped off with a piece of linen cloth;--the plate may then be washed with olive oil, and cleansed as before with dry fine whiting. _Note_--Different artists use a variety of different preparations of varnish for the purpose of etching. In some old recipes, virgin wax, calcined asphaltum, gum mastic, amber, colophony, greek pitch, burgundy pitch, black pitch, resin, shoe makers' wax, &c. &c. are mentioned. But it is believed that the above described varnish, while it is much more simple, will answer equally as well for young practitioners; and it is not expected that any will attempt very nice work, without further information than they could expect to obtain from the sketches in this little collection. 58. ENGRAVING AND SCRAPING IN MEZZOTINTO.--Having prepared a plate of copper, proceed to score it so full of lines, cross-lines and diagonal lines, that when they are filled with ink, the plate may appear quite black. For this purpose an instrument will be requisite that is fashioned similar to a chisel, the round or sloping side being scored or filed near the point, with lines or notches very near to each other, so as to form a set of sharp uniform teeth at the edge; this instrument is called a cradle, and should be a little round at the corners. This cradle must be moved over the plate, in the manner of a graver, scoring the plate uniformly in various directions. When the scoring is finished, take a scraper, which may be similar to a knife, having two edges, and sloping on each side towards the point; with this, scrape off the roughness of the plate, in such places as is required to be the lightest in the print; such parts as require to be shaded partially, may not be scraped so deep, while the points that are to be the brightest may be burnished quite smooth with the polished end of a piece of steel, about the size of a large nail, and some of the heaviest out-lines may be cut with a graver. Thus any portraits or other figures may be formed on the plate, with due proportion of light and shade, and will, if properly-managed, give an impression on paper, equal in elegance to any that might be produced by other means.