When a beater has been running for some time the knives of the roll and the bed-plate become worn and so far reduced that they must be taken out and re-cut. The bed-plate is removed, firmly fixed in the bed of a planing machine, and the edges trimmed by means of a chisel, so as to cut the knives at the proper angle. The roll and bed-plate are shown in section in Fig. 32. Fig. 33 is a plan of a bed-plate, and Fig. 34 illustrates the manner in which the knives are fixed. [Illustration: FIG. 32.] It will be seen that the knives in the bed-plate are placed so that they do not lie parallel with those of the roll. This arrangement imitates to some extent the action of a pair of scissors. Occasionally the knives are slightly bent, so as to form a very obtuse angle. Bed-plates so fitted are called {121} “knee-plates.” They are largely used in America, but not much in this country. [Illustration: FIG. 33.] [Illustration: FIG. 34.] To obviate the necessity of removing the roll, a small machine has been devised whereby the knives can be cut _in situ_. This machine, which can be firmly fixed between the mid-feather and the side of the beater, consists of a small steam-engine which actuates a movable cutter, which is made to pass to and fro horizontally along the edge of each knife in succession. The engine is supplied with steam by a piece of strong flexible rubber tubing. The ordinary form of beater contains only one roll, though some have been constructed containing two or even four rolls. In America, beaters of a totally different construction are much in vogue. The most important of these are the Jordan and Kingsland beaters, so called from the names of the inventors. The former consists essentially of a roll in the shape of a truncated cone, fitted with knives in the usual way, revolving in an iron box of corresponding shape, furnished with knives placed in the direction of its length, but at slightly different angles. The half-stuff enters the beater at the narrow end through a box provided with an {122} arrangement for regulating the flow, and is discharged by two or more openings in the cover at the wider end. The Kingsland engine consists of a circular chamber, the sides of which are covered with knives, and between which a circular plate, also furnished with knives, revolves. The pulp enters through a pipe in the centre of one of the sides of the chamber, and flows out through an opening in the opposite side. Another form of beater is that invented by S. L. Gould. The only essential difference between it and the Kingsland beater is that, instead of having a plate which revolves vertically against two stationary ones, the plate, which is placed horizontally, is furnished with knives on one side only, and revolves upon but one fixed plate, much in the same way as a pair of millstones.