K_{2}O.Mn_{2}O_{7} + 10(FeO.SO_{3}) --> K_{2}O.SO_{3} + 2(MnO.SO_{3}) + 5(Fe_{2}O_{3}.3SO_{3}). From this it appears that two molecules of KMnO_{4} (or 316.0 grams) have given up five atoms (or 80 grams) of oxygen to oxidize the ferrous compound. Since 8 grams of oxygen is the basis of normal oxidizing solutions and 80 grams of oxygen are supplied by 316.0 grams of KMnO_{4}, the normal solution of the permanganate should contain, per liter, 316.0/10 grams, or 31.60 grams (Note 1). The preparation of an approximately tenth-normal solution of the reagent may be carried out as follows: PROCEDURE.--Dissolve about 3.25 grams of potassium permanganate crystals in approximately 1000 cc. of distilled water in a large beaker, or casserole. Heat slowly and when the crystals have dissolved, boil the solution for 10-15 minutes. Cover the solution with a watch-glass; allow it to stand until cool, or preferably over night. Filter the solution through a layer of asbestos. Transfer the filtrate to a liter bottle and mix thoroughly (Note 2). [Note 1: The reactions given on page 61 are those which take place in the presence of an excess of acid. In neutral solutions the reduction of the permanganate is less complete, and, under these conditions, two gram-molecular weights of KMnO_{4} will furnish only 48 grams of oxygen. A normal solution for use under these conditions should, therefore, contain 316.0/6 grams, or 52.66 grams.] [Note 2: Potassium permanganate solutions are not usually stable for long periods, and change more rapidly when first prepared than after standing some days. This change is probably caused by interaction with the organic matter contained in all distilled water, except that redistilled from an alkaline permanganate solution. The solutions should be protected from light and heat as far as possible, since both induce decomposition with a deposition of manganese dioxide, and it has been shown that decomposition proceeds with considerable rapidity, with the evolution of oxygen, after the dioxide has begun to form. As commercial samples of the permanganate are likely to be contaminated by the dioxide, it is advisable to boil and filter solutions through asbestos before standardization, as prescribed above. Such solutions are relatively stable.] COMPARISON OF PERMANGANATE AND FERROUS SOLUTIONS