After these dimensions are settled, the timbers may be considered which form the sides of the ship. A frame of timbers, which appears to be one continued piece, is composed of one floor-timber, U, whose arms branch outward to both sides of the ship; (See plate I. PIECES _of the_ HULL) two or three futtocks V V, and a top-timber, W. The futtocks are connected to the upper arms of the floor-timbers on each side of the ship, and serve to prolong the timber in a vertical direction: and the top-timbers are placed at the upper part of the futtocks for the same purpose. All these being united, and secured by cross-bars, form a circular enclosure, which is called a frame of timbers, _couple d’un vaisseau_. And as a ship is much broader at the middle than at the extremities, the arms of the floor-timber will form a very obtuse angle at the extreme breadth; but this angle decreases in proportion to the distance of the timbers from the midship-frame, so that the foremost and aftmost ones will form a very acute angle. Floor-timbers of the latter sort are usually called crutches. Shipwrights differ extremely in determining the station of the midship-frame; some placing it at the middle of the ship’s length, and others further forward. They who place it before the middle, alledge, that if a ship is full forward, she will meet with no resistance after she has opened a column of water; and that the water so displaced will easily unite abaft, and by that means force the ship forward; besides having more power on the rudder, in proportion to its distance from the center of gravity: this also comes nearer the form of fishes, which should seem the most advantageous for dividing the fluid. When the rising of the midship-floor-timber is decided, we may then proceed to describe the rising-line of the floor, on the stern-post abaft, and on the stem afore. The height of the lower-deck is the next thing to be considered: it is determined in the middle by the depth of the hold; and some builders make it no higher than the stem; but they raise it abaft as much above its height in the middle, as the load-water-mark, or draught of water abaft, exceeds that afore. With regard to the height between decks, it is altogether arbitrary, and must be determined by the rate of the ship, and the service she is designed for. It is also necessary to remember the sheer of the wales, and to give them a proper _hanging_; because the beauty and stateliness of a ship greatly depend upon their figure and curve, which, if properly drawn, will, make her appear airy and graceful on the water.