The instrument may be used in two ways for transparent objects: first, in a vertical position, when the light is to be thrown on the object by the mirror, _b c_; or it may be examined by looking up directly at the light; in the latter case the mirror must be taken away. In viewing opake objects the mirror is not used; as much light as possible must be admitted on them through the circular holes of the tubes. Any object may be viewed by first pushing in the tube, R, and then bringing the tube, _n_, to its focal distance from the object. The telescope, when shut up, is about eight inches in length, and when drawn out, is about twenty inches. It is of the achromatic construction. DESCRIPTION OF AN INSTRUMENT FOR CUTTING THIN TRANSVERSE SECTIONS OF WOOD, Plate IX. Fig. 1. It consists of a wooden base, which supports four brass pillars; on the top of the pillars is placed a flat piece of brass, near the middle of which there is a triangular hole. A sharp knife which moves in a diagonal direction, is fixed on the upper side of the afore-mentioned plate, and in such a manner, that the edge always coincides with the surface thereof. The knife is moved backwards and forwards by means of the handle, _a_. The piece of wood is placed in the triangular trough, which is under the brass plate, and is to be kept steady therein by a milled screw which is fitted to the trough; the wood is to be pressed forward for cutting, by the micrometer screw, _b_. The pieces of wood should be applied to this instrument immediately on being taken out of the ground, or else they should be soaked for some time in water, to soften them, so that they may not hurt the edge of the knife. When the edge of the knife is brought in contact with the piece of wood, a small quantity of spirit of wine should be poured on the surface of the wood, to prevent its curling up; it will also make it adhere to the knife, from which it may be removed by pressing a piece of blotting paper on it. Fig. 2, is an appendage to the cutting engine, which may be used instead of the micrometer screw, being by some practitioners preferred to it. It is placed over the triangular hole, and kept flat down upon the surface of the brass plate, while the piece of wood is pressed against a circular piece of brass which is on the under side of it. This circular piece of brass is fixed to a screw, by which its distance from the flat plate on which the knife moves may be regulated.[38] [38] Many other kinds of cutting engines have been constructed, but the specimens from them have not yet appeared with that perfection which is requisite to this sort of objects; whether it lies in the preparation of the woods, or engine, I do not take upon me to determine. Mr. Custance has certainly produced the most exquisite. EDIT. CHAP. IV. GENERAL INSTRUCTIONS FOR USING THE MICROSCOPE AND PREPARING THE OBJECTS.