The men first remove all pins except those of the four corner guy ropes, or the four quadrant guy ropes in the case of the conical wall tent. The pins are neatly piled or placed in their receptacle. One man holds each guy, and when the ground is clear the tent is lowered, folded, or rolled and tied, the poles or tripod and pole fastened together, and the remaining pins collected. TO FOLD TENTS. For folding common, wall, hospital, and storage tents: Spread the tent flat on the ground, folded at the ridge so that bottoms of side walls are even, ends of tent forming triangles to the right and left; fold the triangular ends of the tent in toward the middle, making it rectangular in shape; fold the top over about 9 inches; fold the tent in two by carrying the top fold over clear to the foot; fold again in two from the top to the foot; throw all guys on tent except the second from each end; fold the ends in so as to cover about two-thirds of the second cloths; fold the left end over to meet the turned-in edge of the right end, then fold the right end over the top, completing the bundle; tie with the two exposed guys. METHOD OF FOLDING PYRAMIDAL TENT. The tent is thrown toward the rear and the back wall and roof canvas pulled out smooth. This may be most easily accomplished by leaving the rear-corner wall pins, in the ground with the wall loops attached, one man at each rear-corner guy, and one holding the square iron in a perpendicular position and pulling the canvas to its limit away from the former front of the tent. This leaves the three remaining sides of the tent on top of the rear side, with the door side in the middle. Now carry the right-front corner over and lay it on the left-rear corner. Pull all canvas smooth, throw guys toward square iron, and pull bottom edges even. Then take the right-front corner and return to the right, covering the right-rear corner. This folds the right side of the tent on itself, with the crease in the middle and under the front side of tent. Next carry the left-front corner to the right and back as described, above; this when completed will leave the front and rear sides of the tent lying smooth and flat and the two side walls folded inward, each on itself.