The vertical edge of the bottom is cut with 20 slots, each about 2½ inches deep. One of these is larger than the others and receives the multiple cable; the others are for the single conductor cables. When in use these slots are numbered clockwise from the multiple-conductor slot, looking down into the box. The lid has corresponding projections or lugs which enter these slots, and which, in position, fit snugly against the cable ends. The cables are held from being pulled out by Turk’s-heads worked upon them. To prevent the cable ends from accidentally slipping out of the slots while joints are being made between them before the lid is put on, the multiple cable is secured by a bolted collar on the inside of the box, the single-conductor cables by clipping their Turk’s-heads under claw-like radial projections cast upon the inside rim between the slots. =The distribution box, 7-conductor.=—This box is used with multiple cable, 7-conductor. It consists of two circular plates of cast-iron 21 inches in diameter and three-fourths of an inch thick united by four 1-inch bolts, which are placed in rounded projections forming the angles of a square. The cables are separately clamped, the top plate overlapping the clamp straps. The multiple cable enters on one side; three single-conductor cables enter on the opposite side, and two on each of the intermediate sides. The top plate is provided with a lowering ring. =The junction boxes.=—These boxes, in different sizes, are used in splicing multiple and single-conductor cables; they consist of two rectangular plates of iron or steel united by four ½-inch bolts at the corners. The plates are hollowed in the middle to form a chamber to receive the Turk’s-heads and the joints connecting the conductors. The ends of the plates are curved to admit the cable ends. The Turk’s-heads are clamped to the lower plate by straps and screw bolts, the cavity of the upper plate covering them when bolted in position. Each cable end is thus made fast before the box is closed. =The distribution box buoy.=—This buoy is used to mark the position of the distribution box during the planting of mines and subsequently, in practice and in service, until such time as the mine commander desires to remove it. It may be either a can or a keg buoy—a beer keg of one-half barrel capacity is well suited for this purpose. =The mine buoy.=—This buoy is used to mark the position of the mine when planted. It may be a small can buoy, preferably cork filled, or a piece of wood with a hole bored through it. The size of the buoy is determined by the swiftness of the current. It is attached to the maneuvering ring of the buoyant mine by 60 feet of ½-inch rope.