The dipping is done in cast-iron tanks (Fig. 11), a series of which is arranged in a row, and cooled by a stream of cold water flowing round them. The tanks hold about 12 gallons, and the cotton is dipped in portions of 1 lb. at a time. It is thrown into the acids, and the workman moves it about for about three minutes with an iron rabble. At the end of that time he lifts it up on to an iron grating, just above the acids, fixed at the back of the tank, where by means of a movable lever he gently squeezes it, until it contains about ten times its weight of acids (the 1 lb. weighs 10 lbs.). It is then transferred to earthenware pots to steep. [Illustration: FIG. 13.--COTTON STEEPING POT.] ~Steeping.~--The nitrated cotton, when withdrawn from the dipping tanks, and still containing an excess of acids, is put into earthenware pots of the shape shown in Figs. 12 and 13. The lid is put on, and the pots placed in rows in large cooling pits, about a foot deep, through which a stream of water is constantly flowing. These pits form the floor of the steeping house. The cotton remains in these pots for a period of forty-eight hours, and must be kept cool. Between 18 deg. and 19 deg. C. is the highest temperature desirable, but the cooler the pots are kept the better. At the end of forty-eight hours the chemical reaction is complete, and the cotton is or should be wholly converted into nitro-cellulose; that is, there should be no unnitrated cotton. [Illustration: FIG. 14.--HYDRO-EXTRACTOR.] ~Whirling Out the Acid.~--The next operation is to remove the excess of acid. This is done by placing the contents of two or three or more pots into a centrifugal hydro-extractor (Fig. 14), making 1,000 to 1,500 revolutions per minute. The hydro-extractor consists of a machine with both an inner cylinder and an outer one, both revolving in concert and driving outwardly the liquid to the chamber, from which it runs away by a discharge pipe. The wet cotton is placed around the inner cone. The cotton, when dry, is removed, and at once thrown into a large tank of water, and the waste acids are collected in a tank.[A] [Footnote A: Care must be taken in hot weather that the gun-cotton does not fire, as it does sometimes, directly the workman goes to remove it after the machine is stopped. It occurs more often in damp weather. Dr Schuepphaus, of Brooklyn, U.S.A., proposes to treat the waste acids from the nitration of cellulose by adding to them sulphuric anhydride and nitric acid. The sulphuric anhydride added converts the water liberated from the cellulose into sulphuric acid.]