To warm the interior of this chamber, which is constructed of any material that will resist the action of the vapours and gases, and which is not too absorbent, Prof. Gardner makes the bottom of the chamber of such a shape as to form a heating vessel to hold water or steam, this water or steam, or both, being kept at the required temperature by means of a steam coil. Matters are so arranged that the contents of this coil are protected from any excess of pressure, and consequently the temperature seldom or never exceeds about 212° F., unless for any special reason it is desired to raise it to a higher point. Sometimes the sides are constructed similarly to the bottom. The materials of which these chambers are constructed must be capable of resisting the heated and acidified vapours within them. Cast or wrought iron faced with glass, slate, tiles, pewter, or glazed bricks; tinned copper, tinned brass, or pewter; timber, whether green or after carbonising by heat or sulphuric acid; all are more or less suitable. Means of observing the progress of the conversion, and means of lifting the contents in or out, must also be provided, as well as thermometers to indicate the temperature prevailing inside. The gases and vapours which effect the conversion of the blue lead into white lead are generated outside the chamber just described, and are conducted into it by means of pipes, being first raised to such a temperature in excess of that which should exist inside the converting chamber as to allow for the cooling effect arising from the friction and loss of heat in passing through the various pipes and distributors attached to the converting chamber. Owing to this extra heating, the gases and vapours are expanded, diffused, and commingled, and do not rob the interior of the converting chamber of any heat on entering it, so that the heat inside the converting chamber is kept constant, and can operate to further expand and diffuse the gases and vapours in contact with the blue lead inside the chamber. In practice it is found that the temperature of the converting chamber cannot be suitably controlled if any portion of the gases or vapours be generated within that chamber.