from first principles, coupled with the assumption that initial stresses do not exist in any form in the metal of the inner tube previous to the hoops having been shrunk on; but if the tube happen to be under the influence of the most advantageous initial stresses, and we proceed either to hoop it or to envelope it with wire, according to the principles at present in vogue, then, without doubt, we shall injure the metal of the tube; its powers of resistance will be diminished instead of increased, because the metal at the surface of the bore would be compressed to an amount exceeding twice its elastic limit. An example of injury inflicted in this way is to be found in the method adopted for hooping cast iron tubes cast by Rodman's process. If we take into consideration the undoubted fact of the existence to a considerable extent of useful initial stresses in these tubes, then the hoops should be put on them either with very little shrinkage or none at all, whereas ordnance authorities everywhere have applied to this case methods which are only correct for tubes which are free from initial stresses. [Footnote 3: In certain cases this, of course, may be an advantage, as, for instance, when the inner tube is under injurious initial stresses; but then, in order to be able to apply the necessary shrinkage, we must know the magnitude of these stresses.] [Illustration: Fig. 2] During the process of hooping guns it is very important to know how to take into account the value and mode of distribution of the prejudicial stresses in the inner tube, should such exist. Knowing these stresses, it is possible, by regulating the tension of the hoops, to reduce the compression of the metal at the surface of the bore to the proper extent, thus doing away with the previously existing tension, and by that means removing a source of weakness in the tube. In precisely the same way in the shrinkage of gun hoops attention must be paid to the character and value of the stresses which arise in the course of their manufacture; otherwise it will be impossible to hoop the barrel throughout in a proper manner. If prejudicial stresses exist in the metal of a hoop before it is put in its place, then, when the gun is fired, if it had been shrunk on with the degree of tension usually allowed, the layer situated in the internal radius will be extended beyond admissible limits, thereby causing the resistance of the gun to be less than that prescribed.[4] [Footnote 4: When the inner tube is strengthened by means of wire, the initial or natural stresses in the latter may be neglected on account of its thinness; but when the thickness of the hoops is reduced, and the number of layers thereby increased, then the value of the initial stresses in these hoops is a very important factor with respect to the decrease or increase Of the powers of resistance of the gun.]