There remain a number of matters that do not directly concern the reconstruction project but which are of sufficient technical importance to warrant comment. Apparently the engine was mounted on a wooden frame consisting of two large oak timbers on each side, say about 10" × 10", one above the other, that probably supported iron saddles in which the two cylinders rested. Between each pair would have been the iron track, or channel, in which the ends of the crosshead travelled, along the axis of the engine in elevation. These frames measured about 9 feet 2 inches, outside to outside, and reached from the beams of the upper deck on either side of the crank hatchway to abaft the mainmast on the lower deck. It is probable that the fore and after ends of the frame were supported by stanchions stepped on the lower deck at the fore end and in the hold at the after end. The crosshead was of iron and probably had shoes at the ends to work in the tracks or channels in the frame. To help steady the crosshead, these shoes probably were a foot or more long, for the loading of the crosshead is spread out. The pitman to the paddle wheel shaft is to starboard of the centerline of the engine; the steam cylinder piston is slightly off center of the frame and crosshead; and the piston of the air cylinder is close to the port engine frame. The steam lines to the valves of the steam cylinder come in horizontally over the frames. As has been mentioned, the frame may also have supported the paddle wheel axle bearings at the crank.