Kitecraft : $b and kite tournaments — John Stuart Mill — John Shaqi
Kitecraft : $b and kite tournaments
John Stuart Mill · en
It is possible to decorate a plain balloon with surface design, but
it must be bold and not over done. An example or two may be helpful,
Figs. 188, 189, 190. Yellow and black, black and red, purple and white,
green and white, and many other good combinations can be selected, but
two or three colors are better than many. The best grade of tissue
paper is very much superior to the cheap, as the tendency of the cheap
to split out is very unsatisfactory and there are thin porous spots.
The French tissues, so called, are the best, and they come in many
shades of good colors.
=Parachutes= are other forms of balloon. They do not ascend from the
ground, but are released up in the air and float downward. Sometimes
a current of air will catch one and carry it far up and away. They
are made like an umbrella covering, sometimes in sections and again
in one piece, Figs. 191 and 192. When made in sections, they are very
much like the upper one-third of a balloon. They are made from the
size of your hand to beauties that are eight feet across; when made
of brilliantly colored paper, they are very interesting. They have
a weight suspended underneath to keep them upright in the descent.
Parachutes are usually taken up on a kite line and are released well
up in the air. The usual method of shaking them off the line is not
as good as a definite release by a tripping string from the ground.
If large ones are used, one at a time is sufficient and is simple to
release. The parachute is tied with a bow-knot to the kite line with
the extra string and as this string is pulled the knot comes untied and
the parachute is released. When smaller ones are used they can be tied
in a series and the lowest down on the string or the highest can be
released, then the next, and so on. The same string can be used to tie
on a long series.
No matter how small the parachute, it must have its suspension strings
and weight. We have tried parachute showers that have only been a
partial success, thus far. A bunch of these little parachutes each
with its own string tied to the kite line, have been released, but
in pulling them up they are so liable to get twisted up, that when
released they cling together. If they could be carefully laid in some
kind of an apron that would protect them from the breeze, I am sure
they might be tumbled out so as to separate without entanglement. It is
a very pretty sight to see a large bunch turned loose, each spreading
its tiny night cap to the air as it starts downward. They should be
of all colors, and for this purpose the one piece models and one foot
in diameter are best. There is always a scramble for the souvenir
parachutes when they are released. If one had a rubber stamp outfit, it
would be interesting to print something on their cover. Thread would be
used for the suspension cords and perhaps a shingle nail for the weight.