At the Potomac River it is about 4 miles in width, at the latitude of Leesburg about 10 miles in width, and thence it spreads towards the east until its maximum width is, perhaps, 15 miles. The area of the Newark formation is, of course, a feature of erosion, as far as its present form is concerned. In regard to its former extent little can be said, except what can be deduced from the materials of the formation itself. Three miles southeast of Aldie and the end of Bull Run Mountain a ridge of Newark sandstone rises to 500 feet. The same ridge at its northern end, near Goose Creek, attains 500 feet and carries a gravel cap. One mile south of the Potomac River a granite ridge rises from the soluble Newark rocks to the same elevation. As a whole the formation is a large body of red calcareous and argillaceous sandstone and shale. Into this, along the northern portion of the Catoctin Belt, are intercalated considerable wedges or lenses of limestone conglomerate. At many places also gray feldspathic sandstones and basal conglomerates appear. The limestone conglomerate is best developed from the Potomac to Leesburg, and from that region southward rapidly diminishes until it is barely represented at the south end of Catoctin Mountain. The conglomerate is made up of pebbles of limestone of varying sizes, reaching in some cases a foot in diameter, but, as a rule, averaging about 2 or 3 inches. The pebbles are usually well rounded, but sometimes show considerable angles. The pebbles of limestone range in color from gray to blue and dark blue, and occasionally pebbles of a fine white marble are seen; with rare exceptions also pebbles of Catoctin schist and quartz occur. They are embedded in a red calcareous matrix, sometimes with a slight admixture of sand. As a rule the entire mass is calcareous. The conglomerate occurs, as has been said, in lenses or wedges in the sandstone ranging from 1 foot to 500 feet in thickness, or possibly even greater. They disappear through complete replacement by sandstone at the same horizon. The wedge may thin out to a feather edge or may be bodily replaced upon its strike by sandstone; one method is perhaps as common as the other. The arrangement of the wedges is very instructive indeed. The general strike of the Newark rocks is a little to the west of north, while the strike of the Catoctin Belt is a little to the east of north. The two series, therefore, if extended, would cross each other at an angle of 20 to 30 degrees. The conglomerate wedges are collected along the west side of the Newark Belt and in contact usually with the Weverton sandstone. The thick ends of the wedges along the line of contact usually touch each other. Going south by east the proportion of the sandstone increases with rapid extermination of the conglomerate. The thin ends of the wedges, therefore, resemble a series of spines projecting outward from the Catoctin Belt.