When compound plugs are prepared for drill or for instruction purposes the use of ruberine or other waterproofing material on the screw threads is omitted; care must be taken that the transformer leads are not needlessly shortened. =Loading a mine.=—The mine case is carried from the storeroom to the loading room and placed on a loading skid or other receptacle with the loading hole up. The plug is removed and the screw threads are thoroughly cleaned. The explosive detail brings in a box of explosive from the explosive house and inserts a loading funnel into the loading hole. The charge for a 32-inch mine case is 100 pounds of explosive. For the larger cases, the charge should be the maximum that the conditions warrant; it is specified at present as 200 pounds, though larger charges are desirable if enough explosive can be obtained and the excess buoyancy of the case will warrant the use of more than 200 pounds. The cartridges of dynamite, the trotol, or the blocks of guncotton are inserted by hand and so placed in the mine case that there will be ample room for inserting the compound plug. Only one box of explosive for each mine being loaded is brought into the loading room at one time. After the proper amount of explosive has been placed in the mine case the screw threads are thoroughly cleaned with button brushes and then coated with ruberine or other material to prevent access of water. The compound plug, with its screw threads similarly coated, is screwed home with the socket wrench, a lead washer being used between the plug and mine case. A bar put through holes in the sides of the skids and through the maneuvering ring will prevent the case from falling over and from turning while the compound plug is being screwed home. In order to insure setting the compound plug tight, it is advisable to tap the end of the lever of the socket wrench a few times with a large mallet or a large wooden bar. The mine cap is bolted on and the mine put in a tank for test. If time admits, it may remain in the water 24 hours. It should show practically the same resistance as the compound plug. If this test be made, the loading wire must be long enough for this purpose. Upon completion of this test the mine is taken from the tank, the loading wire pushed inside the cap to avoid injury in handling, and the loaded mine taken to the planting wharf. The precautions to be observed in handling explosives and loading mines are given in Appendix 1. CHAPTER IV. LOCATING DISTRIBUTION BOX, LAYING MULTIPLE CABLE, AND MARKING OUT MINE FIELD. (NOTE.—The operations in Chapters IV and V are described in what is thought to be the logical order, but circumstances may alter their sequence, and, in fact, several of the steps may be carried on simultaneously.)